The proposed under floor heating would be a system of crossed-linked PEX oxygen-proof pipe connected to a distribution manifold. Areas such as toilets, kitchen and corridors would be left as open circuit zones temperature controlled by the heat pump weather compensation. All other rooms would have thermostat control to limit the temperature in these rooms to the required temperature. The thermostat would control the opening and closing of the heat flow to the loops of the zone that the thermostat is controlling.

The under floor piping would be laid onto the floor insulation and covered by 75mm of screed. The U-value for the floor may be a maximum of 0.15W/m2. All internal and external perimeters must be insulated from the screed to prevent thermal bridging between the screed and the building foundations.

Supply of Components

Evolve is able to supply you with a full range of high quality components. Ranging from pipe - five-layer hi-density polyethylene, manifolds, Quicktrac rapid clip system to digital thermostats and timer modules. Below you will find a selection of our high quality under-floor heating components but there is much more so please contact us with your requirements and we are sure that we will be able to offer you a good solution.

Multi-layer composite pipe

The pipe we use is of an excellent quality and consists of an inside and outside layer of polyethylene of raised temperature resistance (PE-RT) which is tightly bonded to the mid layer aluminium 0.2mm core: welded – horizontal-roller-position.

Inside and outside layers are of special PE composite. Hygienic, toxic free and smooth, it’s middle layer of aluminium is 100% gas/oxygen proof, giving it massive advantages over both metal and plastic pipe.

Evolve gives you full control

Control is the soul of under-floor heating. By using a combination of high quality thermostats and a Logic Controller, we can give you full zone control on every room. This means that when a thermostat calls for heat the signal it sends can switch on the boiler or heat pump and route the warmed water to each of the floors independently.

This is the ultimate in control. We use a Full Programmable Timer/Thermostats which have a setback feature, 7-day timer/thermostat setting for individual day and temperature control.

System Design for Under-floor Heating

Evolve has the facility to design the optimal under-floor heating system for any development - domestic, commercial or industrial.

The benefits of this service are that the total system is professionally designed and
well-documented which will avoid costly problems at installation stage.