Supply of Components
Evolve
is able to supply you with a full range of high quality components.
Ranging from pipe - five-layer hi-density polyethylene, manifolds,
Quicktrac rapid clip system to digital thermostats and timer modules.
Below you will find a selection of our high quality under-floor heating
components but there is much more so please contact us with your
requirements and we are sure that we will be able to offer you a good
solution.
|
|
|
| Manifolds with mixing kit pump and wall inset box |
Actuator - Thermoelectric valve controler |
|
|
|
| Manifold with Mixing Kit |
Electric Innovation Quickrack |
Multi-layer composite pipe
The pipe we use is of an excellent quality and consists of
an inside and outside layer of polyethylene of raised temperature resistance (PE-RT) which is tightly bonded
to the mid layer aluminium 0.2mm core: welded –
horizontal-roller-position.
Inside and outside layers are of
special PE composite. Hygienic, toxic free and smooth, it’s
middle layer of aluminium is 100% gas/oxygen proof,
giving it massive advantages over both metal and
plastic pipe.
Evolve gives you full control
Control
is the soul of under-floor heating. By using a combination of high
quality thermostats and a Logic Controller, we can give you full zone
control on every room. This means that when a thermostat calls for heat
the signal it sends can switch on the boiler or heat pump and route the
warmed water to each of the floors independently.
This
is the ultimate in control. We use a Full Programmable
Timer/Thermostats which have a setback feature, 7-day timer/thermostat
setting for individual day and temperature control.
System Design for Under-floor Heating
Evolve has the facility to design the optimal under-floor heating
system for any development - domestic, commercial or industrial.
The benefits of this service are that the total system is professionally designed and
well-documented which will avoid costly problems at installation stage. |
